Activity Stream

I can take my cubby box out fairly easily, I could take some pictures & measure it in millimetres & post up some rough drawings if you wish, my cubby...

Yes as ^^^ and also check for throttle linkages binding and the vacuum advance.

Thanks for the words of encouragement. Have a look at what I did today! ( apart from going to watch grass track racing)

Not good news. After replacing both batteries, after 30hours of slow charge, the engine would not start. At the first attempt, thebattery seemed...

Just a quick question, at the show this weekend there was a stand displaying a pop up/folding tent, Can anyone remember the name of the company? I...

Thanks Yostumpy :) I can only guess with regards the kerosene that either not many have tried it or that, of those that have, very few are willing...

just looked and bit on lower part of rad and intercooler. would a jet wash be ok to remove mud?

Some good progress! I'm with Holly on the oil leeks - unless its the rear main seal, which I assume its not as that should only leak if running. Got...

No, it won't unfortunately

I wanted a small co2 extinguisher but the smallest is 2kg and a bit too big to mount easily in an accessible place. I've seen the mess powder ones...

The webers are good carbs but do suffer from dirt problems due to the tiny progression drillings close to the butterfly in the venturi, you may want...

I your radiator clogged up with mud?

I get 'a bit peeved' by any spell checker, Roger. I also get peeved at underliner jobbies that won't turn off aswell now, why won't 'they' just let...

Thanks Zollaf pressing the pedal 5 times doesnt make any difference it is a constant humming from the fuel pump? dorsetsmith mine is a 2005 model...

Hi guys I decided to change rad, thermostat, top and bottom hose, bypass hose, p gasket, temp sender and water pump and gasket and I think defo...

I once freed a stuck clutch (not on a Landy but the principle is the same) by putting the back wheels up on axle stands, starting it in 4th gear then...

they are not usually that hard to get off, but if you do decide to get a new mount then it might be worth considering some 2'' dropped mounts for...

Simon, Have a read of the information regarding battery catalysts -...

You're quite right, that's exactly what's happened. Whipped off the mount, will either fight with it or replace it with a shiny new one. Thanks...

its my secend car in iran prouduce 90 and 110 pick up and estetion 1- landrover series 3 orginal whit landrover engein and gear 2-santana (show...

Well, been hard at it from 9am this morning, boiling my nuts in my overalls I have finally repaired the rotting passenger side rear door pillar, wet...

the metal tube inside the rubber has rusted on. you need to cut the rubber away until you can get a chisel in to split the tube and then remove it....

hi westrec thanks of you i mad one box last year but its dont lovly i want some pic ot it for make obout sort of ebay i cant becuse i cant buy of...