intake hose needed

[richdrury]

Hi all im looking for the hose from the wing intake to the air box on a 1992 200tdi 110csw, mine seems to have rubbed on the dipstick pipe and cut through :( , if anybody has one or knows where i can get one i would be very happy as the usuall paddocks and craddocks and the like dont seem to list it,
thanks in advance
mike

[StrangeRover]

the hose from the wing intake to the air box on a 1992 200tdi 110csw
Mike, is it anything like the Disco 200Tdi set-up with the cylindrical air box? Do you have a photo?

[richdrury]

hi there ill get a pic posted on here tonight but yes it does have a cilindrical airbox

[StrangeRover]

ESR370 is the convoluted flex pipe that attaches to the elbow on the bottom of the air-box. Not same number on Disco 200Tdi but looks similar (probably shorter). I'll measure the one I've got.

[Mr_Wuffles]

I have one i think if you still need one?

[richdrury]

hi there, the pipe is still needed, how much would you be wanting for it?

[Mr_Wuffles]

£5?

[richdrury]

PM sent!

[Ben Breese]

Could I be a pain and ask when you get it, could you measure the diameter at the wind intake end, if theres any difference either end please?!
I'm making a better more watertight intake off the back of the wing, need to know the diameter of the hose for the pipe I'm using! Think its 2 inch but would like to know before I take the wing off to fit it and find its the wrong size!

Cheers, Ben

[richdrury]

sure no problem, only to happy to help someone bodge up a landy :p

[Ben Breese]

Good to hear:D And shoud say wing intake end, not wind, but sure you knew what I was on about:rolleyes: Think the pipes the same diameter at both ends anyway, but you never know with L/R!

Cheers, Ben:)

[richdrury]

i know what you mean about L/R, the local stealer wants £56 for that peice of pipe :eek:

[Ben Breese]

You got the measurements for the pipe yet fella? Got some nice stainless from work and a 90 degree bend, just wanna make sure its the right size!

Cheers, Ben

[richdrury]

Sorry Ben but i havent had a reply as yet so no pipe either:( starting to get annoying now as you can emagine.

[Mr_Wuffles]

Hi Rich dying of the flu at the minute i do still have it i'll dig it out and i can confirm it's the same width at each end.

[Ben Breese]

What width is that then:p 2 inch internal diameter IIRC but it could be 2 1/2?? Would be good to have it in mm if thats ok actually. Thanks to both of ya!

Cheers, Ben

[StrangeRover]

Which bit do you need? Does this help?

[richdrury]

Hi strange rover, part needed is No. 13 as shown in attached picture, thanks for the diagram it makes things alot easier

[StrangeRover]

My Disco 200Tdi stuff got buried again!
I only just read this and now it's dark again.
From memory, the two pipes are quite different 13 is the thin-wall convoluted flexible the other is quite substantial (rubbery) and formed specifically for the Disco. If I get a chance, I will take a tape measure in the garage and get back to you by PM.