'turret Rings'

[DONNYDISCO]

Hi folks, anyone out there know the answer to this one ?
Turret rings that fit above the spring under the chassis mount that retain the shock turret! Are they the same stud centers for series one / series two disco's, as they seem to be in short supply for disco 2's.
I have just fitted some new shocks (island4x4 supplied these, brilliant service) and fortunately managed to release the nuts holding the turrets without shearing the studs.:confuseda

[StrangeRover]

Microcat lists RBC100111 (for Disco II) which (I believe) has a rubber coating and uses 4 off FY108047 8mm Nyloc Flange nuts.
However, 572087 for Disco I is plain steel and uses 4off NY108041L 10mm Nyloc Flange Nuts. I have been told that it's possible to fit the later rings to D-I but not vice-versa. I'm guessing it's the hole size rather than PCD.
Not the definitive answer that you were looking for; sorry.

[DONNYDISCO]

soz, wrong statement