Floor nearly finished, phew!!

[spandit]

Used about 170 rivets in total, plus an entire tube of gutter sealant (brilliant stuff - will be buying some more, I expect!!), most of a tin of Hammerite and about 2 litres of Waxoyl. It's not that pretty (although being covered by paint helps) but it's solidly in and secure. I used longer bolts for the seatbelts (7/16") with Nylocs on the end as well, since the original nuts were a bit rusty and worn

Let's just hope it passes the MOT next week...:Countdown

[Underdog]

You should be ok plenty of peeps have done the floor job and passed no problem.

Were the seat belt anchors difficult to remove??????
Mine were a right pain in the butt but a good larruping with WD got the damn things moving after much cursing and swearing. I've known people cut the floor pan out around the anchor bolt before!!!!:eek:

[spandit]

Seat belt anchors were a nightmare. I had to cut around the floor and then cut the clevis pins out so I could get them on the bench. One of the bolts came out once I'd welded a new nut on top, but the other one was cut out. They're back in with new bolts and Nyloc nuts below the original captive nuts...