clutch again

[Discodave]

Just putting this back up at the top, come on has anybody got any Idea's. Has something worn or bent. The clutch is working fine, but is quite heavy and after a while it gets quite hard work.

[Budgie]

Could be one of several things.

Try bleeding the clutch system and see if that has any effect.

Then look at the valve that is positioned under the bellhousing, follow the pipe from the clutch master cylinder down and you'll find it. This lightens the clutch and may be the problem.

If it's not these then the clutch release arm in the bellhousing may be worn and needs replacing, these are known to ware the pivot hole and you finally loose the clutch because the hole has got too large and the arm falls over the pivot.

[Discodave]

Thanks will look into all of that.