epascoe
1st Jun 2006, 07:32
I have a Disco I 3.9 v8i. When cold it starts first time, enough power and good throttle response, but when you drive and it gets up to operating temp it gets a flat spot at pull off. When you switch it off it struggles to start, the only way to get it started it to wind the starter motor for about a minute with the throttle fully open or leave it for a few minutes whereafter to whole process repeats itself.
Whe have changed the coil, ignition module, coil wire, engine temp sensor, air flow meter, check for voltage at coil when cranking, all seems to be ok.
Does any body have an idea wat else it could be. (PS. Vehicle not fitted with imobiliser) :(
Whe have changed the coil, ignition module, coil wire, engine temp sensor, air flow meter, check for voltage at coil when cranking, all seems to be ok.
Does any body have an idea wat else it could be. (PS. Vehicle not fitted with imobiliser) :(